WRAPPING/PIPELINE COATING

Business Type	Manufacturer, Exporter, Supplier, Retailer, Importer
Thickness	4 mm
Length	10 Meter
Width	150 mm, 250 mm, 500 mm and 1000 mm (1×10 Meter)

Preferred Buyer From

Location

India

Shiv Sons Wrapping Tape is a hot applied bituminous tape for corrosion protection as per IS: 10221, it is specially formulated corrosion resistant bitumen compound provides high penetration and high resistance to ageing. Swastik Pipe Wrapping Tape comprises of high tensile strength thermo-fusible HMHDPE film on both the sides. 2 mm Pipe Wrapping Tape is five layer without fiber glass inner core, whereas, 3 / 4 mm thick Pipe Wrapping Tape is seven layer tape with two inner cores; top core is of tough 45 gsm fiber glass and the bottom core is of 15 micron high tensile strength HMHDPE.

APPLICATION :

Coating material for drinking water pipelines, fire fighting pipelines, raw water pipelines in thermal plants etc.
Applied on buried and immersed pipes, fittings and appurtenances to protect them from high corrosive environment.

ADVANTAGES :

Coating material for drinking water pipelines, fire fighting pipelines, raw water pipelines in thermal plants etc.
Applied on buried and immersed pipes, fittings and appurtenances to protect them from high corrosive environment Application

APPLICATION METHODLOGY :

Remove dust, flakes, oil, grease or other loose foreign particles by blasting, wire brush or compressed air.
Leave 200 mm from pipe ends for welding joints. Coat and wrap such left over part of pipe at site after welding and hydro testing.
Apply Primer on cleaned surface at 0.30 L/m2 to get DFT of 30 microns. • Allow the primed surface to touch dry, which may take 5 – 15 minutes.
Show the flame of butane gas torch on to the surfaces till it becomes glossy-smooth.
Apply SWASTIK PIPE WRAPPING TAPE on the primed surface. Provide overlap of 25 mm between two adjoining layers.
Wrap spirally and apply sufficient tension to ensure good adhesion and avoid pockets and bridging to meet holiday detection requirement. Tape joint shall face downward on outside of lap joint.
Complete necessary welding and testing of the joint before coating.
Recommend to apply at the time of pipe erection and lowering inside trenches to avoid any damage.

HEALTH AND SAFETY :

Use goggles and hand gloves during application.
Clean hands with warm water after application.

STORAGE :

Keep under shed away from heat. Do not stack more than three rolls in one column.

Technical Specification

TEST	VALUE
Softening Point	105±5
PENTRATION @25ᵒ C	43891
Filler, %	20-30
Tensile Strength
· Lengthwise for 2 mm	70
· Crosswise for 2 mm	50
Elongation, %,
· Lengthwise for 2 mm	100MIN
· Crosswise for 2 mm	100MIN
Holiday Test, KV
·For 2 mm	4.5MIN
·For 4 mm	12MIN
Tensile Strength
· Lengthwise for 4 mm	250
· Crosswise for 4 mm	80
Elongation, %,
· Lengthwise for 4 mm	15MIN
· Crosswise for 4 mm	15MIN

About Factory

Follow Us On Social

WRAPPING/PIPELINE COATING